CLEANING THE FILTER
1.
During EEach FFlock
— Remove the filter and shake out
the dust. Reinstall the filter according to previous
instructions.
2.
After EEach FFlock
— If necessary, remove the filter and
use compressed air and/or water to clean the filter.
Make sure to squeeze out any excess water from the
filter before reinstalling the filter back onto the filter
sleeve. DO NOT USE A PRESSURE WASHER TO CLEAN
THE FILTER. DO NOT WASH IN A WASHING MACHINE.
High pressure, either water or air, can tear the filter
material. Use standard faucet pressure only. Clean the
venturi tube and cones if necessary using pressurized
air and/or water. Refer to the cleaning instruction
guidelines in this Owner's Manual. Let the heater and
filter dry completely before lighting.
CAUTION
■ Never allow the filter to become fully clogged with dust
and dirt.
■ A dust choked filter will restrict the combustion air,
causing improper combustion.
■ Signs of improper combustion include: backflashing
of flame into the venturi tube, yellowing of the flame
within the burner cone, presence of blue and/or
yellow flames outside of the outer cone or carbon
sooting on the underside of the canopy.
■ At first signs of any of these conditions, clean the
filter.
ATTENTION
■ Do not squeeze or tap the filter while the heater is in
operation.
■ Doing so will allow dust to be ingested within the
venturl tube and cones.
■ Shut the heater off and remove filter in its entirety
and shake out dust
10
Komentarze do niniejszej Instrukcji